More money spent…

We ordered the roll cage today from Protection and Performance, should be ready in 4-6 weeks. We’re having it delivered to Maddison 4×4 so I can go over and fit it there where there are some extra hands available as and when needed.

It’s an expedition external cage to minimise any loss of interior space but with an internal hoop with cross braces that should make it a lot stronger should the worst happen. The cross should also make a handy mounting point for hanging “junk” from.

The roof tent will mount onto the cage too, giving it a good solid method of mounting.

We’re getting a snorkel with the cage so it matches 🙂

It lives :)

Patrick sorted the problem with the gearbox pipe, it turns out that the push on connector wasn’t quite locating. Some of the steel pipe section needed bending slightly to give the flexible pipe a bit more slack so it would push on properly.

So it’s all up and running now and just needs a bit of bedding in and tweaking. The engine seems a bit low on power at the moment so I’ll need to figure out what’s going on there. It’s fine at low revs but seems to hit a brick wall at higher revs.

It moves… while it did !

Finally got the 90 back on the road after it’s engine and gearbox transplant. We took it for a trip over to see Patrick at Maddison 4×4 so he could help me set up the Compushift to improve the shifting pattern for the electronic auto gearbox.

As it turned out this particular “shakedown” revealed a problem with the gearbox oil cooler pipe on the driver’s side. When we pulled into the petrol station for our first diesel fill up, a passer by pointed out an oil leak at the front. As it turned out the gearbox oil cooler pipe had popped off, probably as we pulled onto the forecourt. Didn’t lose too much oil and managed to get the pipe pushed back on again and continued our journey.

Unfortunately that wasn’t the end of that particular problem and while Patrick was doing his stuff and showing me how to set up the shift points we lost all drive. The pipe had come off again and, this time, deposited the contents of the gearbox all over the road. We weren’t far from Maddison 4×4 so a quick phone call brought copious amounts of “cat litter” to mop up the spill and we towed it back.

By this time it was dark and getting late so we borrowed a courtesy car for the night and left the 90 with Patrick to see if he could get to the bottom of the problem with the push on connector.

The plan starts here !

This really starts the ball rolling as far as preparing for the trip is concerned. Our chosen vehicle has a 3.9 litre V8 petrol engine that also runs on LPG. The downside of this for a trip like we have planned is that it’s too thirsty to give us the range we need/want without using all the limited interior space for fuel.

Converting the vehicle to diesel makes the fuel situation and range problem a lot simpler so, with some trepidation our beloved V8 90 is going to have an engine and gearbox transplant. A couple of years ago I rebuilt the vehicle and in the process used the main wiring looms from a TD5 Defender. At the time it meant a lot of work integrating the V8 electrics with the TD5 loom but fortunately I did it in such a way that the main harness was untouched. I also changed the fuel tank to a rear mounted TD5 style so there is room for the ECU box under the driver’s seat !

So, we bid farewell to the glorious burble of the V8 and replace it with a tractor engine.. albeit quite an advanced one by Land Rover standards !

We’ve stuck with the auto, a reconditioned/upgraded unit from Ashcrofts, and tracked down a low mileage “15P” prefix engine back in October. I’ve simplified the fuel system, in comparison to the normal TD5 setup, with an external pump and some bits from a 300TDi.

Mike is going to give me a hand when I’m lifting the engines in/out and Patrick will come over with his box of tricks and set up the ECU once the TD5 is in and ready to fire up. I’ve already taken the rocker cover off and got the injector codes off it. The ECUs (I got a spare one) are both configured for a Discovery at the moment so he’ll also reconfigure them for the Defender. Just in case the weather turns nasty I’ve put my plastic “garage” up on the drive to keep the worst of it off.